The device is connected directly to the bus via the EIB terminal and does not require an additional supply voltage. The physical address assignment and parameter settings can be used with the engineering tool software ETS (version ETS4 or above) with the .knxprod file. Note: It is best to program the physical address before installing.
The main functions of the device are summarized as follows:
● Brightness measuring.
● Motion detector and Presence detector, which can be locked or released viaobject.
● The brightness measuring via internal light sensor or KNX, and the internal sensor measuring can be calibrated via object or a correction factor.
● Presence detector additional HVAC applications control output, suchasheating, ventilating and climate control of the room.
● Motion or Presence detector can be integrated control with ambient brightness.
● Use as single device or as main detector, respectively secondary detector, to extend the presence detection zone.
● Sequence operation for the Motion or Presence detector.
● Integrated 2-level light controller (switching).
● Integrated constant light level controller (dimming) .
