The Touch panel is used in building control systems, which can be mounted on a flush-mounted bus coupler. At the same time, the application module can be also connected with other devices for a system on the bus, and the functions are both simple to operation and intuitive. Users can program it according to the requirement to implement the function systematically.
The Touch panel can be used to control the switch, dimming, blinds, and scene, etc. Each button of the Touch panel correspond one LED with two colors indication. The device can be installed in a conventional 86 mm wiring box.
The bus coupler that connected the Touch panel connects to the bus though the KNX connection terminals and has no use for additional supply voltage. It is available to assign the physical address and set the parameters by Engineering design tools ETS with VD3/VD4 (higher than edition ETS3).
The Touch panel can be used in a wide variety of application areas. The following list provides an overview:
◆ Switching and dimming
◆ Control of blinds and shutters
◆ Sending of values, e.g. water line brightness.
◆ Recall and storage scene
◆ LED indication
Each button of a device can adopt any of the functions described above, and is independent of each other. In addition, left button of touch panel can also be used in association with right button, depend on parameter settings.